Exceptional double mitre saw.
Special fabricated and welded steel bed frame with finish machined, complete with slideways for the mobile head.
Pneumatic head tilting from 22° 30' to 90°.
Automatic descent of safety protection.
Graphic display 240 x 64 pixel.
Accuracy: ± 0,1 mm.
TK 145/10 POWER
Same model of TK 145/10 Gold with predefinited configuration that envisages:
automatic descent of safety protection
device for rh load
profiles automatic height feeler
tanks and pipes for chips
CONSTRUCTION FEATURES
Head tilting from 22° 30' to 90°.
Safety device to avoid crushes between head and mullion.
Wide goniometre for intermediate degrees.
Chips ejection through the head.
Clamps complete with high/low pressure safety device.
Chips chute.
TECHNICAL FEATURES
Blade motor power:
2 x 2,2 kW
Maximum installed power:
5,5 kW
Working pressure:
6 ÷ 7 bar
Power supply:
230 / 400 V - 50 ÷ 60 Hz
Blade motor revolutions:
2800 rpm
Blade shaft diameter:
30 mm
Blade diameter:
500 mm
Maximum cut length:
4000 - 5000 - 6000 mm
Minimum cut length 90°/90° (outer degrees):
290 mm
Dimensions (4000 mm):
5145 x 1650 x 1600 mm
Dimensions (5000 mm):
6145 x 1650 x 1600 mm
Dimensions (6000 mm):
7145 x 1650 x 1600 mm
Weitgh (4000 mm):
1260 Kg
Weitgh (5000 mm):
1360 Kg
Weitgh (6000 mm):
1460 Kg
OPTIONAL
Automatic descent of fully safety protections.
Conveyor belt for chips removal.
Device for rh load.
Profiles automatic heigth feeler.
Exhauster.
Micro dropper minimal lubrication.
Label printer.
Tube for chip removal.
Chips collecting tank.
Voltage conditioner.
SOFTWARE
The machine is equipped with the following software:
Operating system DOS.
Single cuts.
Sequence of cuts.
Profiles codes storage complete with heigth for automatically calculating the cut size on the inclined angles.
Loading of cutting lists originated by ABACUS/TEKNA program.
Blade motor timeout: blade motor automatically turns off after an inactivity period of the machine.
Possibility to work with inches.
Optional programs:
Other optional software:
Extra-short cut.
Extra-long cut.
Automatic in sequence cuts and fixed degree (90° / 90° e 45° / 90°).
Automatic in sequence cuts and variable degrees (90° / 90° e 45° / 90°).
Wings cut.
Typologies: program to set the cuts according to repeating formulas.
Loading of cutting lists originated from different soft ware's than ABACUS /TEKNA.
TK Cutlist Optimizer: office program to generate optimized cutting list.
